Installing VMware Hypervisor 6.7 Part 2

3 years ago
7

Boot Steps:
• Make sure you have a monitor plugged into the VGA port and keyboard/mouse connected
• Plug into bootable flash drive
• During boot, press F11
• Once boot devices appear, select your bootable flash drive and hit enter
• VMWare should start loading off the flash drive

Once VMware is loaded and you have rebooted:
• You should be at a screen with the IP and hostname showing
• If you are using DHCP, don’t worry about the network config part, just change the “Hostname” in the DNS settings
• If using a static address, Hit F2 and enter your credentials
• Go to “Configure Management Network”
• Select the static option with your space bar
• Enter you IP, subnet mask and gateway
• Make sure you input your correct DNS settings and hostname
• Once done, hit ESC and Y to save changes
• Your server should reboot and if you have on the same network, you can now connect to the WebGUI over the network

Disclaimer:
This video is for educational purposes only. Jowers Technology Solutions is in no way associated with vendors mentioned in this video or representative of those vendors.

Link to server used: https://www.amazon.com/gp/product/B07CVPD2DD/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1

Loading comments...