Leg Vise for Workbench - Part 2 // Workbench Add-ons

This is the second part and last part of making the leg vise. In this video I make the jaw of the vise itself, as well as fitting everything together at the end to test out.

All in all, I am quite happy with the vise itself, as it creates a lot of clamping pressure, and will most likely use it as part of the workbench toolkit.

My website:💻 https://ravenfinewoodworking.com/

Follow me on:

📷 Instagram: https://www.instagram.com/ravenfinewoodworking/
🎬 Bitchute Channel: https://www.bitchute.com/channel/ZuU5GZvDlOpy/

Music: Driving Home by Dan-Yan-Key1

00:00 Intro
01:25 Drilling hole for pilot dowel
02:09 Shaping the jaw
03:08 Making the jaw flush with the tabletop
03:49 Sawing out the bottom for floor wedge
04:33 Preparing the the foot piece
05:30 Carving decorations on the face of the vise
06:45 Adding new DIY Danish Oil
07:25 Assembling the vise to table
08:09 Testing the foot wedge
08:44 Testing out the clamping of the leg vise
09:56 Detail shots of leg vise