ArcDroid: Initial Look and Setup Calibration Troubleshoot Tips

New tool in the workshop: The ArcDroid from 2 AM Innovations. An initial look at what it comes with and some solutions I found for setup and calibration issues.

You can check the machine out at www.arcdroidcnc.com
Arc Droid Youtube Channel (Instruction and setup videos): https://www.youtube.com/channel/UCfOTHgtjKJOrclDwURDHJZA/featured

0:56 What it comes with
3:28 Ports and Connections
4:22 Some setup tips
7:33 What to do if you have a bad calibration or have trouble performing your first one.
10:11 Problems with 2 Rail, not reading values
13:02 After Calibration be sure to run G28k, power cycle and Home
14:43 Some initial test cuts