mach1sc

Here is a short video showing the power in tap water and how to extract it. no tricks in this video. the only trick is to use real magnesium and real silver. you can still make a similar battery using aluminum and copper however it will not have as much voltage as my selection of materials. if you know of better materials please post in the comments below. thank you for watching. anode/cathode is confusing to me charging /dis-charging. to restate what i meant silver is + and magnesium is - when checking with meter.

in this video we show a very simple battery. it is 2 cells made with magnesium and silver using common tap water as a electrolyte. you will see 2 silver plates and 2 magnesium plates 1 in each cell. after putting a wet paper towel over the plates they make power after they both are powered up a silver round is used to connect the 2 cells together this makes a led light up. 2 cells are shown because 1 cell does not make the required voltage to light the led. if you know of common materials that make more then 1.7 volts in a single cell with water as electrolyte , please post in the comment section below i get up to 1.7 volts when plates are completely submerged in water. this same type of battery can be made with copper and aluminum however the voltage is only about .51volts per cell i made one with 7 cells and lite this led using copper and aluminum. this is not magic it is an electrochemical process called Galvanic corrosion. you can read about on Wikipedia their chart says Beryllium and Gold would be the best and make more volts.

homemade battery lights led . made with silver and magnesium .water is the electrolyte. copper will work instead of silver, silver just gives a little higher voltage. aluminum would work for the magnesium but you would need 4 cells to light led as alum/cop only gives ,51 volts per cell.

12 hp magnum Kohler motor runs on natural gas almost no modification turns 3-phase ac motor with modified 50-n magnet rotor connected to a 150 amp 3-phase rectifier for ac-dc conversion and power sent thru 10-4 so cord to FM-80 Outback battery charger to charge 48-volt battery bank. gas hose has a restriction in it to slow down the gas flow. when i first did it i thought it would not work but as it turned out i was getting too much gas and overloaded the engine and it would not start until i cut the flow some. i used a 5/16 id hose inside the 1/2 id hose to reduce the gas flow. MDS150A 3-Phase Diode Bridge Rectifier 150A1600V Full Wave Diode Module

this is a cheap way to run any 4 stroke internal combustion engine on natural gas in an emergency. like no gasoline available. if you try this please do not leave it unattended as you may burn your house down or even blow it up. the generator is homemade it produces DC current and voltages from 30v to 150volts depending on speed and load .