DONT TREAD ON ME 3D

Creality direct drive extruder is compatible with the BL touch, but....

Got nearly half way through this print and the support for the lantern broke loose from the print bed. I'll be sure to use more adhesive on the next attempt. Special Thanks To: CoffeeBrandCoffee.com Use my Link:https://coffeebrandcoffee.com/?ref=the_prick And My Promo Code: 3DNoob1776 To Get 5% Off Your Next Order

This is what can happen when you don't use enough adhesive and your print fails. Maybe I could have caught this if I weren't asleep at the time of the failure. Next time I'll have some quality caffeine. Use my referral link: https://coffeebrandcoffee.com/?ref=the_prick And get 5% off your order with PROMO code: 3DNoob1776

Still trying to get the sizing right for the AR lower receivers. Music By: Midnight Commando Special Thanks to: Coffee Brand Coffee https://coffeebrandcoffee.com/?ref=the_prick Promo Code: 3DNoob1776

Trying too solve the problem of undersized prints. Is it the model files that's wrong? I think so, my calibration is good.

How I damaged my printer, and how you can avoid making the same mistake.

This is the Biden's Bane 9in quad picatinny raill AR handguard I got from Cntr'+Pew at https://ctrlpew.com/

This is the Biden's Bane 9in quad picatinny raill AR handguard I got from Cntr'+Pew at https://ctrlpew.com/

This is my first attempt at really putting together a video other than something very basic.

This dragon model failed at 94%. My printer didn't give an error code so I'm left trying to learn to read gcode to figure out what went wrong. But in the words of the Doctor, NEVER GIVE UP, NEVER GIVE IN!

Finally got the camera angle right, so it was time to test the timelapse settings. I printed a 150mm calibration tool to both test the print and timelapse settings. Here's the result. I'm still not happing with the resolution and focus of the camera, but there's only so much this camera can do.

I think i've finally gotten my 3d printer dialed on on the settings I want. I was having trouble with stringing and the model coming loose and ruing the print. I was also having trouble figuring out how to use supports correctly. I don't know it all yet, and probably never will, but I think I know enough now to start printing for other and maybe even selling some prints.