Keith Fenner, Career, Hobbies and Life

Creating a double O'Ring sealed cap plug from Delrin and making a form tool to save some man hours, on shaping out the groves...

Creating a replacement axle tube for a 1972 Oshkosh Sander, that took a shit because of the lack of greasing... Heat shrinking the Axle tube in the cast housing and a internal threading tip, for blind holes...

Creating a replacement axle tube for a 1972 Oshkosh Sander, that took a shit because of the lack of greasing... A tip on adjusting the tailstock while finishing the machining of the Axle tube...

Creating a replacement axle tube for a 1972 Oshkosh Sander, that took a shit because of the lack of greasing... Removal of old worn out axle tube from the cast housing and ruffing out the raw materials to make the replacement, with a tip on turning a straight tube...

A full run down on my Hydraulic press...

A full run down on my Hydraulic press...

Turning the end of a Crank shaft to support a clutch pulley, modified for a go cart...

Me and my Kearney & Trecker, a long coming requested video!

Me and My Kearney & Trecker, a long coming requested video!

Straightening, three twisted, two inch hex drive shafts, or driving helical tools and anchors. I Fabricated a reach over alinement jig, like a no go gage, to adjust the adaptor sockets to be true running...

A clean out on my water tray and draft system after two months of use... Plasma cutting steel is the dirtiest of all metals, when it comes to controlling and cleaning up the Hydrocarbons. This video is a follow along with my own inspections of how my system is doing and modifications I foresee or implement along the way...

Tooling as fast as you can thunk it up and sketch it out...

The competition of fabrication on Childs' air compressor body. A quick note on indexing large parts, at least the way, I found to use. A pretty good look at my one ton swinging davit hoist.

Tacking the lower half of the body components together, on Childs air compressor, then lifting the body shell off to finish in on the weld table...

A collection of first ever video clips, building a sliding gantry for a Net Flaker, to much was going on at the time and never followed through with the videoing! I decided to make it a silent flick of never used footage from 2011.

Refurbishing the top half of Childs air compressor...

A sample of our Bronze Blade making, Rudder jigging that gives you endo line boring capabilities...

Broaching a keyway in a tapered bore and a Tip on making your own shims for broach's...

A good example of how the PlasmaCAM and the jig table, improve the timing and workmanship that goes into building blades, new / newly acquired machines and tools, really do, set you forward... The blade is 304 S/S and the thickness is 3/8"...

Christmas Greetings from Turn Wright Machine Works

A mishap, causes a bit of down time. Whining only adds time to the process of repairing... I was back up and running in about four hours...

Machining the braze build up on a steering knuckle bearing bore, for a four wheel drive 690 loader...

Applying the braze to a worn out bearing race bore, for a steering knuckle, on a four wheel drive 690 loader

Machine prep for brazing up a worn bearing race bore, on a steering knuckle, four wheel drive, 690 loader

Bore and sleeve a sprocket assembly, to suit new bearings What looks pretty chewed up to one, may not to another! Doing proper preventive maintenance is like having a lower deductible on your repair plan...