SNOW BLOWER auger belt replacement easier way.

SNOW BLOWER auger belt replacement easier way. How to replace an auger belt on a snow blower. Maintaining your poulan pro or Husqvarna ST224 or a poulan pro pr300 snow blower ensures it operates efficiently during winter storms. One crucial component to monitor is the auger belt, responsible for driving the snow-clearing auger. If you notice signs of wear or damage on the belt, it's essential to replace it promptly to prevent operational issues. This step-by-step guide will walk you through the process of replacing the auger belt on your ST224 or poulan pro snow blower. ariens snow blower is similar.

Tools and Materials Needed:

Replacement auger belt compatible with ST224 snow blower
Socket wrench 3/8?
Screwdriver or pry bar
Work gloves
Safety goggles
Step 1: Preparation

Ensure the snow blower is turned off and parked on a flat, stable surface.
Disconnect the spark plug wire to prevent accidental engine start-ups.
Allow the snow blower to cool down if it has been recently used to avoid burns.
Step 2: Accessing the Auger Belt Area

Locate the auger housing, typically positioned at the front of the snow blower.
Remove any protective covers or panels obstructing access to the auger belt area. Use a screwdriver to loosen and remove screws holding the covers in place. There are two.
Carefully set aside the covers and place them in a safe location.
Step 3: Removing the Old Belt

Inspect the old auger belt for signs of wear, such as fraying, cracking, or stretching.
If your belt is broken, then there is no trouble to remove. If not, but need to be changed, then
Slide the old belt off the pulley and remove it from the auger assembly.
Step 4: Installing the New Belt

Carefully thread the new auger belt onto the pulleys, ensuring it aligns properly with the grooves. you will need to take belly pan off and release brake by using string or clap. Tip machine up on its bucket and put belt around the pulley for auger, then release brake and put machine back down gently. Then put belt over remaining pulley. You may need to pull the machine over slowly to ride the belt over the pulley.

Step 5: Reassembling the Snow Blower

Reattach any protective covers or panels removed earlier, securing them with the respective screws.
Double-check all connections and ensure there are no loose components.
Reconnect the spark plug wire.
Step 6: Testing the Snow Blower

Start the snow blower engine and engage the auger to ensure proper belt operation.
Listen for any unusual noises or vibrations, which may indicate a problem with the belt installation.
Clear a small patch of snow to confirm that the auger functions smoothly.
Conclusion:
Replacing the auger belt on your ST224 snow blower is a straightforward task that ensures optimal performance during snow removal. By following this step-by-step guide and exercising caution, you can maintain your snow blower's efficiency and prolong its lifespan.
#canada #usa #snowthrower #smallengine
00:00 Introduction
00:53 Poulan rant
04:03 Take belly pan off
04:51 Belt install