Zerks & Wheels, Episode 36, rebuilding a chip collector from the ground up

Howdy YouTubers! the second part of the video goes into the re-assembly of the dust collector. while it may be a rather uncomplicated process, there are a few little important details.as mentioned in the video, i should have waited with cinching the bearings down until the shaft was in its final position. as it was i had to loosen everything back up once the motor went onto the base and the belt pulley was installed on the impeller shaft.also, putting anti-seize paste on the screws and mating surfaces of the taper-lock hub are crucial factors to ensure an easier disassembly in the event of a repair later.

in this part of the video we also correct the many mistakes that were made in the last repair of this machine. there were simply too many to list and the list would take up more space that is available in the description box

#dustcollector #dust_collector #dust_collector_rebuild