tculligan9

Finishing up the garage floor with a second coat of floor epoxy.

Getting the garage floor coated with a layer of Garage Floor Epoxy Made by Rustoleum. It’s Battleship Gray with a Satin Sheen. Got it at Home Depot.

Getting the corners done with the inside and outside pre-built Kerdi Corners.

Kind of a long video that shows one of the last steps of getting the waterproofing membrane installed in custom shower.

Installation of membrane continued for custom walk-in shower. Using Schluter All-set.

Putting a set of electric brakes on my single axle(3500#) trailer.

Using Schluter All-Set to get the second strip of waterproofing membrane installed into custom shower.

Using Schluter All-Set to install waterproofing membrane for custom 7 head shower.

Using Schluter all-set to install the first piece of kerdi Membrane in custom shower.

One last coat of un-modified thin set before the water proofing layer goes in.

Getting shower walls floated out with un-modified thin-set. Also getting shower curb fiber taped and first coated with thin-set in preparation for water proofing membrane.

Getting the walk in shower ready for the Kerdi-membrane.

Getting the durarock ready to be coated and smoothed out with thin set.

Using moen thermo valve and 4 moen 3/4” volume control valves to control all the functions. This video is a tedious step by step guide for those who dare to try it.

Compacting final mud pan to get correct slope to drain

Using up all the extra pan liner on the walls of the bench

Had some pretty old and stained cartridge filters so I decided to see if an acid wash would make them new again.

Using an angle grinder with wire wheel to grind down old rusty security doors. Then painting them to make them look new again.

Building a Copper Manifold for high pressure body sprays. This is for a custom walk in shower.