300PRC : Making Bullets - 198 PVA Solids and N565
https://rumble.com/v2p8tu8-match-rifle-brass-prep.html
In this video I show how to make bullets for the 300PRC Pokemon rifle. Components used are 198 PVA solids, N565, ADG Brass and Federal Match primers. This is also done with cheap tooling: a $30 digital scale, $50 Hand primer, and an OLD RCBS Single stage press.
Press or cry like the rest. Also... Fuck YouTube - that shit is for Beta Plebeians.
348
views
2
comments
Choot'em All Range Day
It had been a long time coming. I had just got the ne Edlebrock Double Pumper tuned so I stacked the back of the truck with ALLs of the Great Stuff. The weather was about the hottest of the year but that did not stop me. It only baked all of the heat-wussies off of the range so there was no waiting on them.
Pistols: CZ BullShadow SAO/Holosun507Comp, CZ SP-01 Open Race Gun, SAR P8L, SAR K12, CZ97B, CZ97E SAO, Ruger MkII Slabside, Ruger MKII 10", Ruger MkIV 10", Ruger MkIV Black Grand Mamba 16"
Rifles: Ruger PC Carbine, M1 Carbine, Eddystone Sporter, M1 Garand, 1903, AR-15 in 6mmARC
Shotgun: Remington 870
1.88K
views
6
comments
Match Rifle Brass Prep
All of the steps that I take in making good quality match rifle brass with a few tips and tricks popped in her and there. This is for a Single Stage setup.
673
views
7
comments
CZ 97B Part 2 - CGW Race Hammer and Wide Shelf Safety install.
Installing the CGW Race Hammer and Wide Shelf Safety in this video. Also fitting a sear to a safety. All on the Big Plopper CZ97 on the quest for SAO Bullseye Fuddrunner.
69
views
1
comment
CZ 97B Build Part 1 - SAO Conversion
CZ97B Part 1 build - CGW SAO trigger, Reduced Power Trigger Return Spring, Floating Trigger Pin and remove the Disconnector from the hammer. Its a long rabbithole watch, but I wanted to get at least some CZ gunsmithing stuff over here on Rumble.
Phase 1 (previous) was E conversion, S2 mag catch, and rear sight.
Phase 3 (next) - CGW race hammer, Shelf Safety, FPB removal, Ext FP/spring.
124
views
1
comment